Bose Companion 3 - Important Notes for Setup and Use; Satellite Speaker Connection Guidance; Control Pod Operation

Il7Jporlant notes for setting up and using your COlfJpanion
rR
) 3 speaker system
Only connect the supplied satellite speakers to the jacks labeled "To Satellites", on the back of
your Acoustimass® module.
A CAUTION: Do not connect any other electronic device to these connectors (Figure 1); doing
so may damage your equipment.
Figure 1
Only connect satellites to
the satellite jacks
Figure 2
Keep arrow side face-up
Figure 3
~
Ir
@L
III @~
~@R
To Satellites
WARNING! Connect only to
satellite speakers provided
o
~
When inserting the control pod connector to your Acoustimass module, be sure the arrow side
of the connector is facing up (Figure 2).
A CAUTION: Inserting the control pod connector other than directed (above) may result in
product damage.
After you have turned on your computer or sound source and power switch (on the back of
your Acoustimass module), you MUST also unmute your speaker system by tapping the
top of the control pod (Figure 3). You can then use the volume ring to adjust the volume.
) Note: The indicator light is yellow when the system is muted, and green when it is active.
Unmute the control pod
Volume-adjustment
ring
Indicator light
Touch-sensitive
mute/unmute switch
PN273708
Rev. 00 JN31136