Bose Lifestyle 18 Series II - Making a Video Connection to the TV

BASIC SYSTEM CONNECTIONS
17

B
ASIC SYSTEM CONNECTIONS
English FrançaisEspañol
Making a video connection to the TV
On your media center, connect the Composite Video Out to the Video input jacks on your TV
(Figure 13).
1. Use the supplied video cable with a single yellow RCA connector on each end.
2. Notice which TV Video input you used, such as VIDEO 1 or VIDEO 3. Write down the
number for future reference in the blank provided on page 16.
Figure 13
Composite video
connection of a TV to the
media center
*A: For use with S-video connections
(for an explanation, see “Higher-quality connections to consider” on page 27).
*B: For use with component video connections
(for instructions, see “Component video connections as another option” on page 33).
Note:
At this point, all required system connections are completed. If you prefer to validate your
system setup now, refer next to “Setting the TV properly is important” on page 21, then follow the
instructions in “Making sure the sound is as good as it gets” on page 24.
Video cable
(delivers DVD and system
menu images to your TV)
TV connection panel
Cable TV, satellite,
or antenna cable
Media center connection panel
Note:
A*
B*
Your TV
rear panel
may look
significantly
different.
It may have
fewer jacks.