Bose Lifestyle 18 Series II - Installing the Remote Control Batteries

BASIC SYSTEM CONNECTIONS
23

B
ASIC SYSTEM CONNECTIONS
English FrançaisEspañol
Figure 18
Power connection for the
media center
Fully extend the power cord, which serves
as an antenna for the remote control.
Media center
power supply
Media center connection panel
DC
power jack
AC (mains)
outlet
Power cable
Note: For dual voltage units (sold in certain areas), MAKE SURE the voltage setting on the
bottom of the media center power supply matches the local power rating (Figure 18). Check
with local electrical authorities if you are not sure of the appropriate power rating.
5. On the media center power supply, insert the small end of the AC power cable into the
power jack.
6. Plug the other end of the power cable into an AC (mains) outlet.
Installing the remote control batteries
On the rear of the remote:
1. Slide the battery compartment cover from the end.
2. Notice the polarity markings (+ and –) inside the compartment and match them with
markings on each of the four batteries as you insert them into the compartment 
(Figure 19).
3. Slide the cover back on the remote until it snaps shut.
Note:
Do not change the settings of the factory-preset miniature switches inside the battery
compartment. They should be changed only as directed in the Reference section of the
Operating Guide.
Figure 19
Remote control battery
installation
+
+
+
+
Battery
compartment
cover
Four (4) AAA (IEC-LR3)
batteries
Replace all four batteries when the remote control stops operating or its range seems
reduced. Alkaline batteries are recommended.