Bose LIFESTYLE BUILT-INvisible TA-2 - System wiring

10
Installation
System wiring
The system can be installed according to either of the following system wiring plans:
• Preferred system wiring (Figure 3) – using the TA-2 connection kit. See “Connection kit” on
page 6.
• Alternate system wiring (Figure 4) – using terminal block connection cables (PC 33946 and
PC 33947). See “Other wall plates and cables” on page 7.
Note: For detailed wiring information, see the instruction sheets included with the system
installation accessories.
As you plan your wiring options, keep in mind:
• The system cable run from the media center SPEAKER ZONE 1 OUTPUT to the TA-2 ampli-
fier AUDIO INPUT must not exceed 150 ft, maximum.
• Cable and wire lengths depend on the placement of the TA-2 amplifier and each device that
connects to it. The following wire recommendations are based on a maximum frequency
response deviation of ±0.5 dB.
Figure 3
Preferred system wiring –
using the TA-2 connection
kit
Gauge Length
18 (0.82 mm
2
) 20 ft (6 m)
16 (1.3 mm
2
) 30 ft (9 mm)
14 (2.1 mm
2
) 50 ft (15 m)
15 amp.
duplex
receptacle
Pow
er
cord
PC33495*
PC33496*
Front
L
C
R
PC33948 (White)*
PC33949 (Ivory)
PC33950(White)*
PC33951 (Ivory)
TV
VCR
Surround
RS
LS
Bose
System
Cable
PC26224*
PC33948 (White)*
PC33949 (Ivory)
* Included in TA-2 Connection Kit
[PC 34245 (White), PC 34246 (Ivory)]