English – 11
SYSTEM SETUP
6. Place your TV on the sound system, making sure the TV base is centered and does
not hang over any edge of the system.
CAUTION: If your TV comes with an anti-tip device, install it according to the manufac-
turer’s instructions and adjust the tether as instructed after placing the TV on top of the
system. Installing an anti-tip device is recommended when using a TV with this product. If
your TV did not come with an anti-tip device, you can get one from most retail TV suppliers.
7. Plug the sound system power cord into a live AC outlet.
A moment after applying power, the system emits two tones indicating that it is ready
to use.
Turning the system on
1. Press the power button on the Bose
®
remote.
2. Turn on your TV.
3. Turn off your TV’s built-in speakers:
To enjoy the full benefit of hearing TV audio through the Solo TV sound system, the
internal speakers in your TV should be turned off. Newer TVs usually have a setup
menu item for turning off speakers. Older TVs may have a speaker on/off switch on
the rear panel near the audio output connectors.
• If you have a TV with a setup menu, use the remote that came with your TV to
locate the menu item and set the TV speakers to off. If your TV does not have a
menu setting for turning off the internal speakers, exit the audio menu and reduce
the TV volume to its lowest setting.
• If the rear panel of your TV has a speaker on/off switch, set it to the off position and
adjust the TV volume to about 80% of the highest volume.
Note: To confirm your TV speakers are off, press Mute on the Bose remote and
check that no sound is coming from the TV.
To Next Page
Loading...
