HOW TO WEAR THE CONTROL MODULE (OPTIONAL)
13
|
ENG
USE THE BELT PACK BRACKET
Attach the bracket to your radio/belt pack
1. On the back of your radio/belt pack, loosen the two screws and remove the
belt clip.
Belt clip
2. Aligning the screw holes, place the bracket on top of your radio/belt pack.
NOTE: The belt pack bracket can be attached to the left or right side of your
radio/belt pack.
3. Aligning the screw holes, place the belt clip on top of the bracket.
Belt pack
bracket
Belt clip
4. Re-insert the two screws from your radio/belt pack and tighten until secure.
HOW TO WEAR THE CONTROL MODULE (OPTIONAL)
To Next Page
Loading...
