Bose Sub1 - Important Safety Instructions; General Safety Guidelines; Warnings and Cautions; Regulatory Compliance

PRO.BOSE.COM/L1 2 OF 6
Technical Specifications
Preliminary
System Performance
Model Name Sub1
System Type Self-powered bass module
Frequency Response (–3 dB)
1
40 Hz to 180 Hz
Frequency Range (–10 dB) 32 Hz to 250 Hz
Nominal Vertical Coverage Pattern 0°
Nominal Horizontal Coverage Pattern Omnidirectional (with –10 dB rear rejection in Cardioid mode)
Calculated Maximum SPL @ 1 m, continuous
2
118.6 dB
Calculated Maximum SPL @ 1 m, peak
2
124.6 dB
Crossover 200 Hz
Transducers
Low Frequency 1 × RaceTrack low-frequency driver 7" × 13"
Low Frequency Voice Coil Size 2"
Driver Protection Dynamic limiting
Amplification
Type Class D
Low Frequency Amplifier Channel 480 W
Cooling Convection cooling
Onboard Mixer
Channels Two
Channel 1 & 2 Input: Audio Type Combination XLR or ¼" TRS connector (mic/instrument/line)
Channel 1 & 2 Input: Impedance 100 KΩ
Channel 1 & 2 Input: Channel Gain +10 dB to +45 dB; from input to driver, controlled by volume control
Channel 1 & 2 Input: Max Input Signal +24 dBu
Channel 1 & 2 Output: Audio Type XLR connector, line-level, full-frequency bandwidth
SubMatch Input: Audio Type Bose proprietary multi-pin cable
SubMatch Thruput: Audio Type Bose proprietary multi-pin cable
LED Indicators Standby, Phase/Pattern selection, Input EQ selection, Output EQ selection,
Signal/Clip Indicator
AC Power
AC Power Input 100–240 VAC (±20%, 50/60 Hz)
Input: Electrical Type IEC, SubMatch
Initial turn on inrush current 14.9 A at 120 V; 29.3 A at 230 V
Inrush current after AC mains interruption of
5 s
5.8 A at 120 V; 32.0 A at 230 V