40
Disassembly Procedures
1. Bottom Housing Removal
1.1 Place the T1 onto a soft surface. Turn
the T1 unit over onto the front panel. Using a
Phillips-head screwdriver, remove the six
screws that secure the bottom housing to
the top housing.
1.2 At the bottom edge of the unit near the
volume controls, carefully separate the
bottom housing from the top housing. Lift off
the bottom housing.
2. Top Housing Removal
2.1 Perform procedure 1.
2.2 Pull off the trim, rotary selector, master
volume and channel volume knobs from the
front panel.
2.3 Turn the unit over onto the front panel
and remove the two screws that secure the
DSP PCB and I/O PCB subassembly to the
top housing.
2.4 Lift the DSP and I/O PCB sub-assembly
off of the top housing.
To Next Page
Loading...
