Bose T1 ToneMatch - Page 67

67
Troubleshooting
Problem What to check
Poor quality
sound from a
microphone or
instrument
connected to
the T1.
• Make sure there is no unwanted zEQ or Para EQ equalization applied.
• Verify that you have selected an appropriate ToneMatch engine preset for
your microphone/instrument. If you do not want to use a ToneMatch engine
preset, make sure ToneMatch is set to flat.
• Make sure there are no unwanted effects (Comp/Gate, Mod, Delay, Reverb)
on your input channel. Check the Status in the Prefs menu for any currently
active effects.
• Check that the T1 input Trim is adjusted properly for your microphone /
instrument. The signal LED should be green; if the LED is red, lower the Trim
level until it is green.
• Try a different microphone or instrument cable.
• Check the cable connecting your microphone or instrument to the T1 audio
engine. Make sure the cable plug is fully inserted into the microphone /
instrument output connector and the T1 input connector.
• Check the settings (if any) on your microphone or instrument.
• Check the batteries (if any) in your microphone or instrument.
Not hearing any
effects.
• Check that you pressed the correct CH Edit button.
• Make sure the FX Mute button is not pressed for the channel in question.
T1 not
responding to
control knobs
• Turn off the audio engine. Wait 30 seconds and turn the unit on again.
Master volume
control has no
effect.
• Verify that the Master output is configured for Post Master Volume operation
in the Prefs menu under Master Out.
With nothing
plugged into the
T1 input
connectors, a
slight hum or
buzz is heard
from the L1
system.
• Plug the T1 and the L1 power stand into the same AC mains outlet.
• Using an AC outlet tester, test the AC outlet that the T1 and/or the L1 power
stand is plugged into for reversed or open hot, neutral and/or ground
contacts.
• If using an extension cord, make sure that the cord is also tested as above.
Too much, or
not enough
bass, mid-range
or high
frequencies.
• Make sure there is no unwanted zEQ or Para EQ equalization applied.
• Verify that you have selected an appropriate ToneMatch engine preset for
your microphone/instrument. If you do not want to use a ToneMatch engine
preset, make sure ToneMatch is set to Flat in the Utility category.
Poor-sounding
playback of a
stereo
recording using
a CD player,
MP3 player or
other such
device.
• Connect the left channel of the device to T1 input channel 4 and the right
channel to T1 input channel 5. Channels 4 / 5 are designed for line-level
inputs.
• Disable any extended bass or EQ features when using CD or MP3 players.
• If you are using recording software on a computer, check the software
requirements. You may need to configure the software settings for 48kHz /
24-bit operation.