How to set your Dolby Digital receiver
Your VCS-1 O@ or VCS-30@ Series II speakers are compatible with
the output from Dolby Digital receivers. Take special care to set
the channel output on the Dolby Digital screen menu to SMALL for
both the center speaker and surround speakers.
Receiver channel output
Proper setting
Center
SMALL
Left and right surround speakers
SMALL
(KS-30 Series II surround speakers)
Follow the receiver owner’s guide instructions for using the
receiver test tone to verify your connections and to adjust the vol-
ume levels of the speakers.
If the sound is interrupted
The VCS-10 Center Speaker and VCS30 Series II Center/Sur-
round Speaker System feature an advanced automatic electronic
protection circuit to prevent speaker damage due to an overload.
When the center channel speaker detects an overload, the protec-
tion circuit intermittently shuts down and resets the speaker a
fraction of a second later, until the overload is cleared. Intermittent
play will continue for the duration of the overload.
If you hear this interruption, turn down the volume to relieve the
overload. You will hear the speaker resume normal play when the
volume is set at a safe level.
> Note: The overload problem described here should occur only if
the receiver is overdriven and sending a distorted signal, or when
the center speaker is driven by an amplifier rated well above the
100 watts per channel maximum listed in “Compatibility” on
page 15.
13
How
to
set
your Dolby Digital receiver
Your VCS-1
O®
or
VCS-30® Series
II
speakers are compatible with
the
output
from Dolby Digital receivers. Take special care
to
set
the channel
output
on the Dolby Digital screen menu
to
SMALL
for
both the center speaker and surround speakers.
Receiver channel output
Properseffing
Center SMALL
Left and right surround speakers SMALL
(YCS-30 Series
II
surround speakers)
Follow the receiver owner's guide instructions
for
using the
receiver test tone
to
verify your connections and
to
adjust the vol-
ume levels
of
the speakers.
If
the sound is interrupted
The VCS-1 0 Center Speaker and VCS-30 Series
II
Center/Sur-
round Speaker System feature an advanced automatic electronic
protection circuit
to
prevent speaker damage due
to
an overload.
When the center channel speaker detects an overload, the protec-
tion circuit intermittently shuts
down
and resets the speaker a
fraction
of
a second later, until the overload is cleared. Intermittent
play will continue for the duration
of
the overload.
If you hear this interruption, turn
down
the volume
to
relieve the
overload. You will hear the speaker resume normal play when the
volume is set
at
a safe level.
) Note:
The
overload problem described here should
occur
only
if
the receiver is overdriven
and
sending a distorted signal,
or
when
the center speaker is driven
by
an amplifier rated well above the
100 watts
per
channel maximum listed
in
"Compatibility" on
page
15.
13
To Next Page
Loading...
