Surround speakers in the VCS-30@ Series II speaker system pro-
vide surround sound effects from the rear of vour viewing area
(Figure 4).
Figure 4
Alternate choices
for placing the
surround speakers
Position your surround speakers
Surround speakers
Brackets that come with these speakers allow you to mount them
on the wall. If you use the supplied brackets, refer to the bracket
instruction diagrams in the Appendix. Do not connect the speak-
ers before reviewing those instructions.
If you prefer, set the speakers on a table or shelf in a horizontal
position.
A
CAUTION: Do not install near any heat sources, such as radia-
tors, heat registers, stoves, or other apparatus (including amplifi-
ers) that produce heat.
For accurate surround sound:
l
Place these speakers behind the general viewing area, along the
rear wall or to the rear of side walls.
l
Place both speakers at the same height.
l
Place the speakers as far apart as your room allows.
l
To mount the speakers on brackets, be sure to leave room
between the end of the bracket and the wall for tightening the
bracket screw.
Figure 5
Applying self-
adhesive feet to
the bottom of a
surround speaker
Figure 4
Position your surround speakers
Surround speakers
in
the
VCS-30®
Series
II
speaker system pro-
vide surround sound effects from the rear
of
your viewing area
(Figure
4).
Alternate choices
for placing the
surround speakers
Surround speakers
Brackets that come with these speakers allow you
to
mount them
on the wall. If you use the supplied brackets, refer
to
the bracket
instruction diagrams
in
the Appendix. Do not connect the speak-
ers before reviewing those instructions.
If you prefer, set the speakers on a table or shelf
in
a horizontal
position.
A CAUTION:
00
not install near any heat sources, such as radia-
tors, heat registers, stoves,
or
other apparatus (including amplifi-
ers) that produce heat.
For accurate surround sound:
• Place these speakers behind the general viewing area, along the
rear wall or to the rear of side walls.
• Place both speakers at the same height.
• Place the speakers as far apart as your room allows.
•
To
mount the speakers on brackets, be sure to leave room
between the end of the bracket and the wall for tightening the
bracket screw.
Figure 5
Applying self-
adhesive feet to
the
bottom
of
a
surround speaker
•
•
•
•
•
7
To Next Page
Loading...
