7 EN
REGULATORY INFORMATION
Product Power State Table
The product, in accordance with the Ecodesign Requirements for Energy Related Products Directive
2009/125/EC and the Ecodesign for Energy‑Related Products and Energy Information (Amendment)
(EU Exit) Regulations 2019, is in compliance with the following norm(s) or document(s): Regulation (EC)
No.1275/2008, as amended by Regulation (EU) No.801/2013.
Required Power State Information
Power Modes
Standby Networked Standby
Power consumption in specified power
mode, at 230V/50Hz input
< 0.5 W Wi‑Fi,
Bluetooth
< 2.0 W
Time after which equipment is
automatically switched into mode
< 2.5 hours < 20 minutes
Power consumption in networked
standby if all wired network ports are
connected and all wireless network ports
are activated, at 230V/50Hz input
< 2.0 W < 2.0 W
Network port deactivation/activation
procedures. Deactivating all networks
will enable standby mode.
Wi-Fi: Reactivate from networked standby via the Bose Work
application. Deactivate by restoring the factory default settings:
Press and hold the Home and Autoframe buttons on the
remote control simultaneously for 5seconds.
Bluetooth
: Reactivate from networked standby by restarting
audio from a
Bluetooth
source. Deactivate by restoring the
factory default settings: Press and hold the Home and Autoframe
buttons on the remote control simultaneously for 5seconds.
External Power Supply Technical Information
The external power supply provided with the product, in accordance with the Ecodesign Requirements
for Energy Related Products Directive 2009/125/EC, is in compliance with the following norms(s) or
documents(s): Commission Regulation (EU) 2019/1782.
Manufacturer Bose Products B.V.
Commercial registration number 36037901
Address Gorslaan 60
1441 RG Purmerend
The Netherlands
Model identifier DT24V‑1.8C‑DC
Input voltage 100V–240V
Input AC frequency 50Hz/60Hz
Output voltage 24VDC
Output current 1.9A
Output power 45W
Average active eciency 89.9%
Eciency at low load (10%) 87.0%
No-load power consumption 0.07W