5
Mounting On Dashboard
See the section “Installation precautions” on page 2.
Use only installation parts provided with the product. Using other mounting
methods may void the warranty.
Before you drill or cut any holes, investigate your vessel’s layout very carefully.
Take special care when you work near the gas tank, fuel lines, hydraulic lines
and electrical wiring.
1. Cut a mounting hole (Ф 3.13” / 79.5 mm) in the dashboard.
2. Slip the unit through the mounting hole in the dashboard.
Ø 3.13” / 79.5 mm
3. Fasten the unit to the dashboard with the supplied U-bracket and two bolts and nuts.
If needed, remove one or more break-away tabs on the U-bracket to shorten the bracket
for rm fastening to the dashboard.
Break-away
tabs
To Next Page
Loading...
Need help?
General
