Boss DD-200 - Page 14

Overall Settings (Menu)
14
Parameter
Explanation
Syn
(SYNC)
Species the tempo clock to which this
unit will synchronize.
int
(INTERNAL): Synchronize to the internal
tempo.
Aut
(AUTO): Normally synchronize to
the internal tempo, but if MIDI clock is
being input via the MIDI IN connector,
synchronize the tempo to MIDI clock.
If you’re using the DD-200 as a slave
device, choose the “Aut” setting.
RtS
(REALTIME SOURCE)
Species the source of realtime messages
that are output to the MIDI OUT connector.
int
(INTERNAL): Internal realtime messages
are the source.
Mid
(MIDI): Realtime messages from the
MIDI IN connector are the source.
MtH
(MIDI THRU)
Species whether MIDI messages received
at the MIDI IN connector are retransmitted
without change from the MIDI OUT
connector (on) or are not retransmitted
(oFF).
LoP
(LOOP SWITCH)
Species whether the looper is used (on)
or not used (oFF).
If this is “oFF,” you can’t enter looper
mode.
Parameter
Explanation
P1–Pg,
P10–Pgg,
P.00–P.28
Specify the memory corresponding to the
received program number. Bank select is
ignored (received regardless).