Need help?Do you have a question about the Boss Delay DM-2 and is the answer not in the manual?
General| Type | Analog Delay |
|---|---|
| Input Impedance | 1 MΩ |
| Output Impedance | 1 kΩ |
| Recommended Load Impedance | 10 kΩ or greater |
| Delay Time | 20 ms - 300 ms |
| Controls | Delay Time, Repeat Rate |
| Power Supply | 9V battery or AC adaptor |
| Dimensions | 73 mm (W) x 129 mm (D) x 59 mm (H) |
| Weight | 400 g |
| Accessories | Owner's Manual |
Controls the repetition rate of echoes.
Controls the intensity of the returning echo and feedback.
Controls the output level of the echo.
Input jack powers the unit; output jack provides low-noise amplifier connection.
Connects the AC adaptor for power.
Shows unit status (ON/OFF) and battery level.
Features silent FET switching for clean operation without clicks.
Allows tool-free battery replacement under the footswitch plate.
Illustrates how to connect the DM-2 to an amplifier and instruments.
Set all knobs, depress pedal, and check LED for effect ON/OFF and battery status.
Adjust REPEAT RATE and INTENSITY knobs for desired echo and feedback effects.
Turn the ECHO knob to set the output level of the delayed sound.
Advises on battery removal, effect degradation from low voltage, and AC adaptor usage.
Details BOSS AC adaptor usage for AC operation and warnings about using different adaptors.
Step-by-step guide on how to replace the 9-volt battery, including opening and closing the pedal.
To Next Page
