Need help?Do you have a question about the Boss DC-2 and is the answer not in the manual?
Connect the supplied AC adaptor for AC operation.
Connect to amplifiers for sound output; use Output A for mono.
On/Off switch for the effect, uses FET for click-free operation.
Lights when effect is on; dimming indicates battery replacement.
Buttons to select one of four preprogrammed Dimension modes.
Connect to instruments; plugging it in turns the unit on.
Connect the supplied AC adaptor for AC operation.
Connect to amplifiers for sound output; use Output A for mono.
On/Off switch for the effect, uses FET for click-free operation.
Lights when effect is on; dimming indicates battery replacement.
Buttons to select one of four preprogrammed Dimension modes.
Connect to instruments; plugging it in turns the unit on.
General| Inputs | 1 x 1/4" instrument |
|---|---|
| Outputs | 1 x 1/4" |
| Bypass | Buffered |
| Power Supply | 9V DC |
| Input Impedance | 1 MΩ |
| Output Impedance | 1k ohm |
| Recommended Load Impedance | 10 kΩ or greater |
| Dimensions | 73mm (W) x 129mm (D) x 59mm (H) |
| Controls | Mode selector (I, II, III, IV) |
To Next Page
