2
WWW.BOSSWELD.COM.AU
BOSSWELD GAS WELDING EQUIPMENT
Thank you for your purchase of our BOSSWELD Brazing/Heating Kit portable brazing & heating kit. The BOSSWELD range of gas
welding and cutting equipment has been rigorously tested by independent laboratories and conforms to the following Australian
Standards for gas welding and cutting processes:
BOSSWELD strives to meet all relevant Australian Standards. Should there be change to existing or creation of new Australian
Standards, BOSSWELD will endeavor to ensure that all products and services comply with those standards.
This manual refers to safety measures that must be adhered to for the safe operation of your BOSSWELD Brazing/Heating Kit
equipment. Please read and understand these warnings and instructions before use. Failure to do so could result in serious
injury or death. BOSSWELD brazing and heating equipment should only be used by operators who are properly trained and
qualified in the safe use of this type of equipment.
GENERAL SAFETY INFORMATION
Safety consideration for both the operator and surroundings must be given to the heat source produced by mixing compressed
oxygen with a fuel gas and igniting the resulting mixture. When using these processes, particular safety considerations apply
with respect to:
a) Do not leave the Brazing/Heating Kit torch unattended when lit, or put it down
b) Burns from flames, hot objects, malfunctioning hand-held equipment, molten particles, etc.
c) Explosions from mixed gas concentrations created by fuel gas leakage from cylinders,
d) Fire caused by ignition of flammable materials, leakage of fuel gases, contact with hot slag, poor condition of welding
equipment, etc. (Plant, building, ship and bush fires have occurred)
e) Use welding goggles when using the Brazing/Heating Kit.
d) Do not breath welding fumes
e) Violent rupture or explosion of components due to pressurisation beyond their designed working pressures
f) Asphyxiation due to the displacement of atmospheric, breathable air by inert or toxic gases. For example, leakages in
confined spaces or lack of oxygen resulting from excessive rusting in confined spaces
g) Radiation damage (to eyes principally and other exposed surfaces)
h) Fumes originating from the particular materials being welded and heating
BOX CONTENTS
1
HEATING & BRAZING KIT
WWW.BOSSWELD.COM.AU
• Single Gauge Oxygen Regulator
• Single Gauge Fuel Gas Regulator
• Fixed Shade 5 Brazing Goggles
• 2.5m Oxygen/Fuel Hoses
• Brazing Nozzles: Sizes 0, 1, 2, 3
• Spark Lighter
• Combination Spanner
• Lightweight Carry Case
Disposable Gas Bottles Sold Separately
TIP SIZE ORIFICE WELDING RANGE
0# 0.7mm 0.5mm - 1mm
1# 0.8mm 1mm - 2mm
2# 0.9mm 2mm - 3mm
3# 1.0mm 3mm - 4mm
NOZZLE CHART
To Next Page
Loading...
