4
WWW.BOSSWELD.COM.AU
DO NOT CONNECT CYLINDERS BEFORE YOU HAVE READ THIS MANUAL IN FULL AND UNDERSTAND IT.
THE BRAZING/HEATING KIT OXYGEN BOTTLE CONNECTION ONLY CONNECTS TO M10x1 THREAD.
THE BRAZING/HEATING KIT MAP-PRO CONNECTION IS CGA 600.
GAS SAFETY
The regulators supplied ensure a low and constant flow and pressure. Inspect all parts of the equipment for wear or loose
connection before use. If you have a leaking hose or connection, close all valves regulators and torch handles, and ensure
you ventilate the area you are working in. and remove this equipment from and flammable sources. Do not attempt to fix any
damaged parts contact your nearest Bossweld service agent or Bossweld directly.
• Always make sure the flame is fully extinguish after use before place the torch on any surface.
• Check hoses for kinks or bends.
• Keep flame away from cylinders, regulators, hoses and other persons.
• Only use this product in a well ventilated space - never use in a confined area.
• Make sure the cylinder holder is on a flat surface - do not drag the cylinders or cylinder holder by the hoses.
• Ensure the work area is clean and remove all flammable objects and fire hazards.
• Always wear the appropriate PPE equipment when operating this equipment.
IN CASE OF FIRE
• In the event of a fire, if it is safe to do close the oxygen valve, this should extinguish the flame and also if safe close the fuel
valve and remove the equipment from the area.
• Extinguish the fire with the appropriate equipment only if it is safe to do so.
• If you are unable to turn of the valves or extinguish the fire leave the area, warn any other persons in the area and contact
emergency services
- Phone 000.
TIP REPLACEMENT
Make sure you use the tool supplied and that tips are installed straight as not to wear the thread, this can result in a leak.
• Ensure tip has cooled after use before replacing.
• Do not over tighten
• Ensure tip is clean and dry before installing and is not blocked.
GAS SAFETY INFORMATION
To Next Page
