To Next PageTo Next Page
Need help?Do you have a question about the Bostitch SB-100SX and is the answer not in the manual?
Details model, length, height, width, and weight of the stapler.
Lists tool model, staple series, gauge, and fastener range.
Describes the type of air fitting required for the tool.
Specifies the recommended operating pressure range for optimal performance.
Details the air volume required per minute at a specific pressure.
Specifies the type of male plug and its free-flowing characteristic.
Outlines requirements for air hoses, including pressure rating and quick disconnect.
Emphasizes using clean, regulated compressed air only.
States the need for a pressure regulator within a specific range.
Advises against exceeding the maximum recommended operating pressure.
Explains the role of air filters in preventing wear and maintaining performance.
Details frequent lubrication needs and recommended oils.
Provides recommendations for cold weather lubrication and storage.
Step 1: Pull red pusher handle to latch, opening the cover.
Step 2: Insert staple stick into magazine and slide forward.
Step 3: Pull pusher handle back and rotate clockwise to contact staples.
Explains how to operate the sequential trip model by engaging the contact trip and trigger.
Check A: Ensure tool does not cycle when contact trip is pressed without trigger.
Check B: Ensure tool does not cycle when trigger is pulled off work.
Check C: Ensure tool does not cycle when trigger and contact trip are pressed.
Check D: Ensure tool cycles when trigger is pulled with contact trip pressed.
Use tool only for its intended purpose; do not alter or modify without approval.
Carry by handle, never by hose; do not leave unattended with air hose attached.
Operate only with legible warning labels; report leaks or malfunctions.
Exercise caution when working with the pusher spring assembly due to its nature.
Recommends using BOSTITCH replacement parts and avoiding modified parts.
Ensures internal parts are clean, lubricated, and O-rings are coated before assembly.
Highlights the importance of adequate air volume and identifies flow restrictions.
Cause: O-ring cut or cracked. Correction: Replace O-ring.
Cause: Loose nose screws. Correction: Tighten and recheck.
Cause: Air supply restriction. Correction: Check air supply equipment.
Cause: Tool dry, lacks lubrication. Correction: Use BOSTITCH Air Tool Lubricant.
Cause: Low air pressure. Correction: Check air supply system to tool.
Cause: Bent fasteners. Correction: Use only recommended fasteners.
General
