To Next PageTo Next Page
Need help?Do you have a question about the Bostitch SX150 and is the answer not in the manual?
Mandates wearing ANSI-compliant eye protection against flying particles.
Highlights need for hearing and head protection in specific environments.
Prohibits certain gases and warns against excessive air pressure.
Covers connector design, trigger/contact arm warnings, and air supply disconnection.
Critical warnings to prevent accidental actuation during tool loading.
Emphasizes careful handling, trigger use, body positioning, and contact arm checks.
Advises extra care when evaluating problem tools during maintenance.
Details length, height, width, and weight for each tool model.
Lists compatible fastener series, crown width, wire size, and range for each model.
Describes operation using contact trip with single or rapid fastener placement.
Explains operation requiring work contact before trigger pull for precise placement.
Details operation using trigger interlock and trigger, without a contact arm.
Requirements for air fittings, hoses, and quick disconnects for safe operation.
Prohibits specific gases; details regulator requirements and maximum air pressure.
Emphasizes correct pressure and the role of filters for performance and wear.
Step-by-step visual guide for loading fasteners into specific tool models.
Step-by-step visual guide for loading fasteners into specific tool models.
Explains single fastener placement and rapid fastener operation methods.
Describes operation requiring work contact before trigger pull for precise placement.
Explains cycling using trigger interlock and trigger without a contact arm.
Procedures to verify correct function of the contact trip mechanism.
Procedures to verify correct function of the sequential trip mechanism.
Procedures to verify correct function of the trigger operated mechanism.
Recommendation to use only genuine or equivalent replacement parts.
Guidance on cleaning and lubricating internal parts and O-rings during assembly.
Importance of adequate air volume and pressure, and troubleshooting supply restrictions.
Common causes and corrections for air leaks in trigger valve housing/stem.
Common causes and corrections for air leaks in frame/nose components.
Common causes and corrections for the tool not cycling properly.
Common causes and corrections for reduced power or slow cycling.
Common causes and corrections for intermittent fastener feeding.
Common causes and corrections for fasteners jamming in the tool.
General
