BougeRV CR 35 - Troubleshooting Common Issues; Common Issues and Solutions; Error Code Explanations

7.Troubleshoot
Issues
Suggestions
Refrigerator does not work
Check if the switch is on.
Check if the plug and socket are connected well.
Check if the fuse has been burnt.
Check if the power supply is malfunctioned.
Switching on/off the fridge frequently may cause start delay of the]
compressor.
Refrigerator compartments
are too warm
The door is opened frequently.
A large amount of warm or hot food was stored recently. Wait for
the refrigerator to reach its selected temperature.
The refrigerator has been disconnected for a period of time.
Food is frozen
The temperature was set too low, please increase the temperature]
There is a “water flow”
noise from inside the fridge
It's a normal phenomenon, caused by the flow of refrigerant.
There are waterdrops
around the refrigerator
casing or door gap
It's a normal phenomenon, the moisture will condense to water
when it touches a cold surface of the refrigerator.
The compressor is slightly
noisy when starting
It's a normal phenomenon, the noise will be reduced after the
compressor works stably.
Code F1 displayed
Possible cause: low voltage to fridge.
Adjust the battery protection from H to M or from M to L.
Code F2 displayed
Possible cause: condenser fan is overloaded.
Disconnect power to fridge for 30 minutes & re-start.
Code F3 displayed
Possible cause: the compressor starts too frequently.
Disconnect power to fridge for 30 minutes & re-start.
Code F4 displayed
Possible cause: compressor not kicking in.
Disconnect power to fridge for 30 minutes & re-start.
Code F5 displayed
Possible cause: overheating of the compressor & electronics.
Disconnect power to fridge for 30 minutes & re-start.
Code F6 displayed
Possible cause: no parameter can be detected by the controller.
Disconnect power to fridge for 30 minutes & re-start.
Code F7 or F8 displayed
Possible cause: temperature sensor is faulty.
Contact manufacturer for service.
*For models with FSAK-002 detachable battery, if code F1 displayed, unplug or turn off the
battery, or connect to DC12/24V/AC100-240V(using the adapter) power supply to power the
compressor and battery in time to avoid long-term micro-current draining the battery.