BougeRV CR65 - Troubleshooting Guide

TOUBLESHOOTING
Issues
Cause/Suggestions
Refrigerator does
» Check if the switch is on.
« Check if the plug and socket are connected well.
« Check if the fuse has been burnt.
aretoo warm
notwork « Check if the power supply is malfunctioned.
- Switch on/off the fridge frequently may cause start delay of the compressor]
Refrigerator « The door is opened frequently.
compartments « Alarge amount of warm or hot food was stored recently.
« The refrigerator has been disconnected for a long time.
Food is frozen
« The temperature was set too low.
Thereis "water flow”
noise from inside the
refrigerator
+ It's a normal phenomenon, caused by the flow of refrigerant.
There are waterdrops
around the refrigerator
casing or door gap
« It's a normal phenomenon, the moisture will condense to
water when it touches a cold surface of the refrigerator.
The compressor is
slightly noisy when
starting
+It's a normal phenomenon, the noise will be reduced
after the compressor works stably.
CodeF1displayed
+ Possible cause: low voltage to fridge.
Adjust the battery protection from High to Medium or from Medium to Low.
Code F2 displayed
+ Possible cause: condenser fan is overloaded.
Disconnect power to fridge for 5 minutes & re-start.
If the code shows again, contact manufacturer for service.
Code F3displayed
+ Possible cause: the compressor starts too frequently.
Disconnect power to fridge for 5 minutes & re-start.
If the code shows again, contact manufacturer for service.
Code F4 displayed
+ Possible cause: compressor not kicking in.
Disconnect power to fridge for 5 minutes & re-start.
If the code shows again, contact manufacturer for service.
Code F5 displayed
+ Possible cause: overheating of the compressor & electronics.
Disconnect power to fridge for 5 minutes & re-start.
If the code shows again, contact manufacturer for service.
CodeF6 displayed
- Possible cause: no parameter can be detected by the controller.
Disconnect power to fridge for 5 minutes & re-start.
If the code shows again, contact manufacturer for service.
Code F7 or F8 displayed
+ Possible cause: temperature sensor is faulty.
Contact manufacturer for service.
0