Getting Started
1-5
Polarity
Please note that the 3050 Mono Power Amplier conforms to the
standard of pin 2 as the “high” or “hot” pin for the balanced input.
The Polarity of the 3050 Mono Power Amplier is such that a
positive-going transition at pin 2 will produce a positive-going transition at
the “+” output terminal.
Connecting Your Loudspeakers
Do not use any wrenches on the loudspeaker binding posts. Tighten
these connectors only by hand.
WARNING: This is a high-power amplier. When driven, there is high
voltage potential at the terminals. Connections should be made with the
mains disconnected.
Select spade terminals which accept 6 mm or .250 inch diameter
binding posts. Two sets of output connections are provided to enable easy
passive biamping.
There is no provision for the use of banana plugs. These plugs
have been proven to come loose over time which increases the contact
resistance and distortion. For the same reasons we also do NOT
recommend the use of banana plugs at the speaker end.
Getting Started
Getting Started
To Next Page
Loading...
