I. ASSEMBLY: (continued)
2) Attach the Upper Stem to the back of the
detector body with the two knobs supplied.
3) Depress the button on the lower stem and
push the lower stem into the upper stem.
4) Wind the search coil cable around the
two-piece stem.
5) Leave some slack
in the cable as
you reach the
end of the lower
stem.
6) Attach the coil to
the lower stem
using the attached
coil knob.
7) Install two (2) 9-volt
ALKALINE batteries (not
supplied). There are two
battery doors on the back of
the detector body.
IMPORTANT: Use 9-volt ALKALINE
batteries ONLY.
To Next Page
Loading...
