Bounty Hunter Tracker IV User Manual

OWNER’S MANUAL
Important Facts to Know
about your Metal Detector.
1. This is a MOTION detector.
You must sweep the searchcoil from side-to-side to
detect metal.
A motionless searchcoil over a metal object will not
result in detection.
2. Do not use indoors. Detector is for outdoor use only.
Household appliances emit electromagnetic fields, which can interfere with your
detector. If conducting an indoor demonstration, turn the sensitivity down and
keep the searchcoil away from appliances such as microwaves, computers and
televisions. If your detector beeps erratically, turn off appliances and lights.
Do not test by placing coins on the floor. Most floors contain metal.
Keep the searchcoil away from floors, walls, and tables, which can contain
metal.
3. Use 9-volt ALKALINE batteries only.
Do not use Heavy Duty batteries.
Do not use ordinary Zinc-Carbon batteries.
4. Adjust sensitivity to a low level in the event of false signals
Always begin use at reduced sensitivity.
Increase to full sensitivity after you are familiar with the detector’s operation.

Bounty Hunter Tracker IV Specifications

General

Category	Metal Detector
Model	Tracker IV
Operating Frequency	6.6 kHz
Modes	3 (All-Metal, Discrimination, Tone)
Number of Target ID categories	3
Sensitivity Adjustment	Yes
Depth Indicator	No
Ground Balance	Preset
Search Coil	8-inch waterproof coil
Batteries	2 x 9V
Display	Analog
Target Identification	Three-tone audio
Length	Adjustable from 44" to 51" (112 - 130 cm)
Intended Use	Coin, relic, and general purpose metal detecting