BÖWE M21 - Maintenance Summary and Programs

59
M21-M26-M30
11. Maintenance
11.
Attention: Warranty claims will only be accepted if maintenance has
been performed properly! Follow safety regulations!
All recommendations concerning maintenance are minimum
requirements and refer to a one-shift operation!
11.1 Operation and Maintenance Summary
11.1
When starting operation:
Weekly:
 Turn on steam supply
 Turn on room ventilation system
 Run multi-maintenance program P49
 Drain water from compressed air armature
 Turn on cooling water supply
 Clean the sprayer dirt strainers and
spray nozzles
 Turn on compressed air supply
 Open condensate valve
 Check limit switch function
 Turn on machine main switch
 Start deodorizing program P43, press "STOP"
button when program ends and
signal sounds.
Monthly:
 Execute multi-maintenance program P50
 Check solvent levels in the tanks
When stopping operation:
 Clean strainers in water and steam feeders
 Turn off machine main switch
 Lubricate cage bearing
 Turn off steam supply
 Check post-filter, clean
 Close condensate valve
 Turn off cooling water supply
 Vacuum pump’s operating material tank
empty, clean and refill
 Turn off compressed air supply to compressor
 Turn off room ventilation system or switch to
night operation
Semi-annually:
 Have the flash point of the solvent checked
Inspection and maintenance work:
 Check air cooler, clean
Daily:(before starting the first cycle)
 Clean tanks
 Check machine for leaks
 Retighten screwed unions
 Check solvent safety trough for solvent
 Check V-belt tension, re-tension
 Clean button trap strainer and lint filter (see
11.5.1)
 Dispose of process water in accordance with
the regulations that apply in your country!
Annually:
 Machine inspection (according to BGR 500
chapter 2.14)
 Check the liquid level of the cleaning agent
container
 Remove filter discs and clean in the
machine (program P6)
 Machine is ready for operation
 Check back wall of cage, clean
Daily: (after the last cycle)
 Execute distillation maintenance program P45
Attention:
 Immediately close the loading door
and maintenance openings again.
 (Alternatively start with 15 E during the last
charge)
 Use only lithium-based lubricating
greases, such as.
- ALVANIA 3 (SHELL) - MARSON L2 (FINA)
- BEACON 2 (ESSO) - LGMT 3 (SKF)