Assembly Instructions
For The Bowflex Motivator
Before you begin, you will need three wrenches, a cresent wrench, a 9/16", and a 1/2" open
end wrench, (It is useful to use the cresent wrench to hold one end of a bolt while tightening
with the other) and a phillips head (+) screw driver. Please follow these assembly instructions
carefully. If you experience any difficulty please call a Bowflex customer service representative
and ask for assistance. 1-800-269-3539.
Unpacking Your Motivator
Your Motivator comes in two boxes. One Square box and one long box. See Below
Contents of square box. Contents of long box.
1 Base Frame
1 Pulley Frame
1 Lower Mast
1 Rear Legs
1 Standing Platform
1 Bench
1 Seat
2 Handgrips
1 Ankle Cuff
1 Parts and bolt bag
1 Training Manual
1 Set of Assembly Instructions
See Bolt Bag I.D. and size Guide
for Bolt Bag Contents
Please check to make sure all parts are
included. If you are missing any part, please
call a customer service representative at
1-800-269-3539.
1 Main Beam (Seat Rail)
1 Verticle, Rod Box, & Rod Pack Assembly
To Next Page
Need help?
General
