Pre Start Inspection and Operation
3.29
4. Lower the attachment to begin work.
NOTE: If you want to reverse the operation of the attachment, move the joystick (Item 1,
Figure 3–36) to the REVERSE position.
• Make sure not to travel to fast for operating conditions when using a trencher,
tiller or other attachment that requires the machine to move.
• Stop all machine travel before releasing the joystick.
5. When using a trencher, tiller or other attachment that requires the machine to move while
the attachment is in operation, move the travel control levers slightly in either the forward
or reverse position. Using too fast a travel speed can create an unsafe operating condition
or cause damage to the machine. If the engine begins to labor or stalls, release the travel
controls completely until the engine returns to full operating power.
CAUTION
To Next Page
Loading...
