Boxym bpw1 - 6 Memory Function; Memory Recall; Read Average Value

V1.0
12
The machine is in
good working
condition, but the
results of each
measurement is
different
Mental state and the measured time
will cause measurement values
changes in blood pressure
Before measurement ,Please take a
deep breath and keep in a quiet state
Note: Blood pressure is dynamic, so
must be some difference between the
measured value every time
The measured
values of arm and
wrist is different
Please refer to the "relevant Wrist Blood Pressure Monitor"
The measured
values of blood
pressure is different
with doctors
measured, even
serious small
Record results of your daily blood pressure test, using which to consult with
a doctor
PS: Frequent consultation with a doctor may cause Psychological stress, wh
ich will let your blood pressure test value higher than value under a relax sta
te
Other anomalies
Please press the start button and
check again or change a new battery,
if still can’t measure pleasure connect
us.
6 Memory function
6.1 Memory Recall
This blood pressure storing 2×99 set memory value, each measurement it will automatically
stored. When it stored 2×99 set memory value, the old value will be covered by the new one. It
can show the latest 3 times average value.
Attention

In order to make a note of measurement correctly, before measurement, please make sure set
the right user and time. Under one user, it has stored 99 set data, when you save the 100th set
date, the earliest one date will be deleted.
6.1.1 Read Average Value
Short press the MEMORY key it will show the latest 3 times average value. It will appear
“AVG” in the lower-left corner;
Attention