Boyd S2601 - Introduction

3
SCHM-001
Rev 2
Intended Use and Application of Product
This product is designed to comfortably posion paents during dental surgical procedures. The chair back, toe and base are
adjustable to allow the most ergonomic working posion for the doctor and their assistant(s).
Warranty Statement
All Boyd manufactured products are warranted against defects in material or workmanship only. No other warranes are
expressed or implied. This warranty shall extend for three (3) years for parts and one (1) year for labor. The Boyd warranty only
covers products manufactured by Boyd. Products distributed, not manufactured, by Boyd carry the stated manufacturer’s
warranty.
The warranty period commences upon invoice date of the equipment. Wrien noce of breach must be submied to Boyd
Industries, Inc. within this period. Boyd reserves the right to repair or replace, at its sole discreon, the item in queson.
Warranty is voided if items are misused or product is improperly maintained or installed. The warranty does not cover any
alteraon of the product from its original condion or if product is used in any way other than the product’s design intent.
An authorized service technician must perform all service and maintenance. Any warranty labor must be rst approved by Boyd.
Failure to coordinate warranty service may result in denial of warranty repair. Wrien log and receipts for service must be
maintained to validate the warranty on Boyd manufactured products.
No claim for consequenal damages will be allowed. Freight damage or mishandling by any third party will not be considered a
warranty item. Improper installaon by a third party causing damage to the equipment is not a warranty item.
Introducon
Congratulaons
on your purchase of the Boyd Surgery Chair
Boyd Industries, Inc. has spent years designing and developing the best dental products available in the world today. The
following features make your Boyd chair the most advanced and funconal surgery chair available in the market:
 All steel frame construcon
 Motorized back, toe and li column base
 Motorized lt control for Trendelenburg posioning
 15.81” vercal stroke
 Three (3) operator designated pre-set posions
 Auto return to HOME switch
 Choice of extendable headrests
 Snap in / snap out upholstery
 Smooth, quiet, low voltage D/C motors
 Rail Mount Arm Boards (Oponal)
 Hand Control (Oponal)