Boyd S2601 - Safety Tips; Precautions

5
SCHM-001
Rev 2
1. Medical Electrical equipment requires special precauons regarding EMC and needs to be installed and put into service according to
the EMC standards.
2. Portable and mobile RF communicaons equipment can aect medical electrical equipment.
3. The use of accessories, transducers, and cables other than those specied, may result in increased emissions or decreased immunity
of the S2601 & S2605 Chair.
4. Read instrucons:
All safety and operang instrucons should be read before this product is operated.
5. Follow instrucons:
All use and operang instrucons should be followed.
6. Owner’s manual:
Retain safety and operang instrucons for future reference.
7. Heed warnings:
Adhere to all warnings labeled on equipment and in owner’s manual.
8. Accessories:
Use only accessories from Boyd Industries, Inc. catalog on this chair. Third party accessories will void the warranty and may be
unsafe.
9. Cleaning:
Use mild detergent in water on all painted surfaces and plasc parts. Use only cleaners specically designed for cleaning
disinfecng vinyl upholstery. Refer to vinyl manufacturer’s documentation for specific cleaning information.
10. Line cord:
This product is equipped with a polarized, grounded, alternang current line plug. This plug will t into the power outlet only
one way. This is a safety feature. If you are unable to insert the plug into your outlet, contact a local electrician to correct the
problem with the A/C outlet.
11. Power cord protecon:
Power supply cords should be routed so that they are not walked on or pinched by any other equipment placed upon or against
them and will allow access to disconnect the device. Accessory cords aached to outlets on the chair should be clear from
pinching during operaon as well as paent’s entrance and exit of the equipment.
12. Liquid and object entry:
Do not intentionally pour liquids of any kind on this equipment or push objects of any type into openings as they could touch
moving parts or dangerous voltage points inside equipment which could cause fire hazard, electric shock and/or bodily injury.
13. Servicing:
Do not attempt to service this product yourself. This action will void any warranties. Opening covers could expose you to
dangerous current and mechanical pinch points. Service should only be performed by qualified service personnel. Contact Boyd
Technical Services Department for authorized technicians in your area.
14. Damage or failures requiring service:
Unplug equipment from power source and refer to a qualified service technicians if any of the following occur:
 Power supply cord is damaged.
 Liquid has been spilled into equipment.
 Objects have fallen into equipment.
 Equipment has been exposed to rain or water.
 Equipment has been dropped or damaged.
 Equipment shows significant change in operation.
 Equipment does not operate normally.
15. Replacement parts:
Contact Boyd Technical Services Department to order approved replacement parts. Unauthorized substitutions could result in
electrical shock, fire hazard and/or bodily injury.
16. Safety checks:
Upon the completion of any service to equipment, service personnel must perform safety checks to insure that all equipment
is functioning properly and safely.
17. Heat / Open flame:
Equipment should be installed away from heat sources such as radiators, heat registers, stoves, or other products that produce
heat or open flames. There should be no smoking in a room where this equipment will be operated or stored.
Safety Tips and Precauons
This product has been designed and tested with your safety in mind. Improper use can result in electric shock or other physical
injuries. Do not defeat the safeguards that have been designed into this product. Please read and observe the following safety points
when installing and operang this product. Save this manual and all supplemental literature for future reference. Observing
precauons listed in this booklet will help you get many years of service and safe operaon from your equipment.