STARTING ENGINE
To start the engine
1. Set the parking brake.
2. Make sure the Engine Stop Switch
Lanyard is attached before attempting to
start
3. Place the Fuel Petcock to the “ON”
position
4. If engine is cold, place the choke lever
to the “ON” position (pulled out).
Note: If the engine is already warm the
choke may not be needed.
5. Pull the Pull Start Cord
6. Once engine has warmed up for a few
minutes, place the choke to the “OFF”
position (pushed in).
Starting or running the DTV in an
enclosed area such as a garage or
shed where there is no ventilation
is hazardous
Inhaling exhaust fumes from the
DTV can cause severe injury or
death
Never start or run the DTV in an
enclosed environment where there
is no ventilation. Always start and
run outdoors.
!
WARNING
RIDING THE DTV
Engine Stop Switch Lanyard
Choke
Pull Start Cord
Fuel Petcock
Parking Brake
13
To Next Page
Loading...