DESCRIPTION AND PART FUNCTIONS
Brake Lever: Brakes are applied when the
brake lever is pulled toward the hand grip.
Thumb throttle lever: Throttle is
applied by depressing the Thumb Throttle.
Engine Kill Switch Lanyard: The engine
will not start and will stall if running, when
the Kill Switch Lanyard is removed from
the DTV.
Note: Always wear the Lanyard Strap
around wrist while operating DTV
Choke Lever: If the engine is cold, the
choke can help start the engine by pulling
out the choke lever to the “ON” position.
Once engine has warmed up , push in the
choke lever to the “OFF” position.
Pull Start Cord: To start the engine, Pull
the Pull Start Cord.
Note: Make sure the Engine Kill Switch
Lanyard is attached before attempting
to start the engine. Engine will not run
without the Engine Kill Switch Lanyard
attached.
Handle Lock Release Lever: Handle can
be adjusted when the Handle Lock
Release Lever is pulled toward the hand
grip.
Fuel Tank Cap: To open the fuel tank
cap, turn the cap counter clockwise to
remove. To re-install the cap, turn the
cap clockwise until snug. Make sure the
cap is seated properly .
Choke
Pull Start Cord
Thumb Throttle
Engine Kill
Switch Lanyard
Brake Lever
Handle Lock
Release lever
Fuel Tank Cap
5
To Next Page
Loading...