B+K precision 830C - Page 88

86
Note: If static recording function is disabled, all
queries will return an error message on display
until the function is re-enabled again. Use
CALCulate:AVERage:STATe command shown
below to control static recording function.
CALCulate:AVERage:STATe <Boolean>
Description: Enable or disable the static
recording function of the calculation.
Example: CALC:AVER:STAT OFF
CALCulate:LIMit
:MODE <mode>
:LOWer <mode>, <value>
:UPPer <mode>, <value>
Description: Set the mode or the value of the
Limit function.
Parameter:
<mode>: The value of mode is from 01 to 25.
<value>: The limit value is from 00000 to 11000.
Example:
CALC:LIM:MODE 01 ; Apply the settings of
the mode 1.
CALC:LIM:UPP 07,01000 ; Set the upper limit
value of the 7
th
set.