To delete all the badges relative to a group, press the call button relative to the GROUP
whose badges you wish to delete. If the group is valid, the indicator LED remains on
and steady and you move on to the next stage of programming J.
Press the call button again. A long tone will confirm the correct procedure K.
N.B. In each of the two stages of programming, any error condition will be indi-
cated by three quick beeps. Repeat the stage correctly.
At the end, reposition the RFID PROG jumper in the rest position L.
The product complies with the applicable reference directives.
Dismantling and disposal. Dispose of the packaging and the device properly at the end of its life cycle, according to the regulations in force in the country where
the product is used. The recyclable components bear the symbol and code for the material.
THE DATA AND INFORMATION PROVIDED IN THIS MANUAL ARE SUBJECT TO CHANGE AT ANY TIME WITHOUT PRIOR NOTICE.
MEASUREMENTS, UNLESS OTHERWISE INDICATED, ARE IN MILLIMETRES.
To Next Page
Loading...
