3
3
2
CLIK!
1
2
1
A
B
>2 cm
6
7
8
Installation on plasterboard walls
Press the box against the wall to get four reference
points where the holes with a 10 mm diameter will
be made (fig. 3).
Cut the plasterboard to obtain the hole where the
box will be inserted.
Remove the three tabs as shown in figure 4.
Insert the upper part A of the fastening clamps into
the box, leaving the lower part B free (fig. 5).
Place the embedding box into the hole and then
apply the lower part B (fig. 6).
Secure the box to the wall with the screws provided
(fig. 7).
If the wall is more than 2 cm thick, the two parts of
the fastening clamps will need to be separated, posi-
tioning the lower part B as shown in figure 8.
To Next Page
Loading...
