LUBRICATION
408A BACKHOE
H
H
6745
12-13-95
GENERAL INFORMATION
Economical and efficient operation of any machine is dependent upon
regular and proper lubrication of all moving parts with a quality lubricant.
Neglect leads to reduced efficiency, heavy draft, wear, breakdown, and
needless replacement parts.
All parts provided with grease fittings should be lubricated as indi-
cated. If any grease fittings are missing, replace them immediately. Clean
all fittings thoroughly before using grease gun.
IMPORTANT: Avoid excessive greasing. Dirt collects on exposed grease
and greatly increases wear. After greasing, wipe off excessive grease from
fittings.
LUBRICATION SYMBOLS
The following symbol is used on the lubrication diagram printed on
the following page. It is reproduced here with its meaning for your conve-
nience.
Lubricate daily or every 8 hours of operation, whichever comes
first, with SAE Multi-Purpose Lubricant or an equivalent SAE
Multi Purpose type grease.
CAUTION! Shut off vehicle engine before lubricating equipment.
8
To Next Page
Loading...