To Next PageTo Next Page
Need help?Do you have a question about the Bradford White EF120T4003NA3 and is the answer not in the manual?
General| Type | Gas |
|---|---|
| Energy Factor | 0.95 |
| Height | 72 inches |
| Diameter | 30 inches |
| Fuel Type | Natural Gas |
| Tank Capacity | 120 Gallons |
| Thermostat | Yes |
| Warranty | 6 Years |
| Capacity | 120-Gallon |
Tables detailing maximum vent lengths for different pipe sizes and models.
Explains reasons for system lockouts and associated error codes.
Schematic illustrating electrical connections and component layout.
Initial steps for diagnosing a non-operating water heater with a blank display.
Details the buttons and display of the water heater control system.
Steps to enter and navigate the diagnostic mode for service.
Instructions for adjusting the water heater's temperature setpoint and display format (°F/°C).
Details error codes, their definitions, and the actions required to correct them.
Table of sensor resistance values correlated with temperature readings.
Step-by-step guide for removing and installing the thermostat sensor (thermistor).
Instructions for safely removing the combustion system assembly from the water heater.
Instructions for installing the combustion system assembly with a new gasket.
Procedure for visually inspecting the burner tube for damage or deterioration.
Step-by-step guide for replacing the burner tube with a new one.
Instructions for safely removing and replacing the gas valve assembly.
Step-by-step guide for removing and installing a new blower motor.
Procedure to measure exhaust tube pressure using a manometer.
Instructions for safely removing and installing the exhaust pressure switch.
Step-by-step guide for removing and installing the flame sensor.
Procedure for measuring and adjusting the spark rod gap for proper ignition.
Instructions for safely removing and installing a new spark rod.
Step-by-step guide for replacing the ignition control board.
Instructions for safely removing and installing the transformer.
Instructions for safely removing and installing the vent safety switch.
Procedure for inspecting and replacing the powered anode system.
