Bradley 600 Series - User Manual

P.O. Box 309, Menomonee Falls, WI USA 53052-0309
PHONE 800.BRADLEY (800.272.3539) FAX 262.251.5817
bradleycorp.com
Installation
HDWL-INSTR-003 Rev. D; ECN 13-14-030B
© 2013 Bradley
Page 1 of 15 8/29/2013
Plastic Laminate
Restroom Partitions
Ceiling-Hung — Series 600
Table of Contents
Pre-Installation Information ....................2
Layout Dimensions for Brackets ................3
Mounting Brackets to Wall .....................4
Leveling Brackets to Pilasters ..................5
Mounting Brackets to Pilasters ...............5–6
Pilaster Mounting Hardware ...................6
Panels & Pilasters .........................7–8
Pilaster Shoes ..............................9
Hinges .................................9–11
Latch and Strike/Keeper ..................12–13
Urinal Screens ..........................14–15
IMPORTANT
Read this installation manual completely to ensure proper installation, then file it with the owner
or maintenance department. This installation manual provides instruction for the assembly of
normal partition configurations and standard components. Non-standard configurations or
components including but not limited to curved or angled walls, partial walls, oversized panels,
or modified hardware are not covered in this manual. Compliance and conformity to local codes
and ordinances is the responsibility of the installer.
Separate parts from packaging and make sure all parts are accounted for before discarding
packaging material. If any parts are missing, do not begin installation until you obtain the missing
parts. To prevent warping, always lay the material flat. Do not lean the material against the wall or
stack unevenly.
Before beginning installation, make sure that the wall and floor backing are adequate to support
the secure mounting of the toilet compartment units.
To minimize break-out, always use a support block when drilling through plastic laminate
material. Use caution when drilling. Accuracy is important!
Product warranties and parts information may be found on Bradley's web site at bradleycorp.com.
Installation
THIS
SIDE
UP
Packing List
•
•
•
•
*HDWL-INSTR-003*
For Standard Height
Doors and Panels Only

Summary

Important Installation Guidance

Manual Usage and Scope

Read manual completely, file it, and understand it covers normal configurations only.

Installer Responsibilities

Installer is responsible for compliance with local codes and ordinances.

Parts Handling and Site Preparation

Verify parts, prevent warping, ensure adequate backing, and use support blocks for drilling.

Layout Dimensions for Brackets

Stirrup Bracket Layout

Determine panel and pilaster centerlines for stirrup bracket installation.

Continuous Bracket Layout

Determine panel and pilaster centerlines for optional continuous bracket installation.

Mounting Brackets to Wall

Stirrup Brackets to Wall

Position, mark, drill, and secure stirrup brackets to the wall.

Continuous Brackets to Wall

Pilaster Bracket Installation

Leveling Brackets to Pilaster

Stirrup Brackets to Pilaster

Optional Bracket Installation

Continuous Brackets to Pilaster

Pilaster Mounting Hardware

Panel and Pilaster Assembly

Panels and Pilasters with Stirrup Brackets

Panels and Pilasters with Continuous Brackets

Door Hardware Installation

Wraparound Gravity Hinges

Continuous Spring-Loaded Piano Hinge

Latch and Strike;Keeper

Latch and Strike;Keeper for Inswing Doors

Latch and Strike;Keeper for Outswing Doors

Urinal Screen Installation

Urinal Screens with Stirrup Brackets

Urinal Screens with Continuous Brackets

Bradley 600 Series Specifications

General

Brand	Bradley
Model	600 Series
Category	Bathroom Fixtures
Language	English