Bradley Express SS Series

Questions and Answers

M
Morgan HarrisAug 11, 2025
What to do if my Bradley Bathroom Fixtures have limited water flow?
- E
  evan99Aug 11, 2025
  If you're experiencing limited water flow with your Bradley Bathroom Fixtures, it could be due to dirt and debris buildup in the valve or strainer. First, ensure both hot and cold water supplies are connected to the Navigator mixing valve and have water flow. Then, remove the cover and U-clip, take out the cartridge, and clean the strainer. You can use silicone grease on the cartridge if desired, but avoid using grease on check valves.
E
Eric GravesAug 17, 2025
Why is the water temperature fluctuating in my Bradley Bathroom Fixtures?
- S
  Steven RamirezAug 17, 2025
  Fluctuations in water temperature in your Bradley Bathroom Fixtures might occur if the water supply is not 10° above the desired set point. In this case, you should increase the hot water supply temperature. Another potential reason is that the temperature is not properly set. You can adjust the temperature as instructed on page 7, step 5.
A
Amy PeckAug 23, 2025
What to do if there are external leaks in Bradley Bathroom Fixtures?
- B
  briannamooreAug 23, 2025
  If you notice external leaks in your Bradley Bathroom Fixtures, it's likely due to a damaged cartridge or O-rings. The suggested solution is to replace the cartridge with part number 269-1927.
R
Rebecca WatsonSep 4, 2025
How to fix a Bradley Bathroom Fixtures station that won't shut off and drips?
- M
  Michelle NicholsonSep 4, 2025
  If an individual operating station of your Bradley Bathroom Fixtures won't shut off and is dripping, it's likely due to an internal cartridge failure. The suggested solution is to replace the S27-352 cartridge.
E
erik54Nov 27, 2025
What to do if Bradley Bathroom Fixtures station fails to turn on?
- M
  Michelle BanksNov 27, 2025
  If an individual operating station of your Bradley Bathroom Fixtures fails to turn on, it could be due to a failed cartridge for the valve or a loose electrical connection to the terminal. To determine the cause, test the station: 1. Disconnect the wires from the cartridge of an adjacent valve and from the problem valve, then reconnect them to the adjacent valve. 2. Turn on the electrical and water supplies. Pass your hand in front of the sensor of the problem station; the adjacent station should turn on. If it does and cycles normally, replace the cartridge on the problem valve. If it doesn't, inspect the wires from the sensor cable, ensuring there are no breaks and that the fully insulated disconnect terminals are firmly crimped. Turn off the electrical and water supplies, reconnect to...

Bradley Express SS Series Specifications

General

Category	Bathroom Fixtures
Material	Stainless Steel
Finish	Satin
Mounting Type	Wall Mounted
Flow Rate	0.5 GPM
Installation Required	Yes
ADA Compliant	Yes
Product Type	Lavatory System
Activation	Sensor
Number of Stations	1
Number of Handles	0