Brady Bradyprinter 200MVP - Page 70

60 Bradyprinter 200MVP and 300MVP User’s Guide
&OHDQLQJWKH&XWWHU0RGXOH
(Cutter option required)
:$51,1*)RUSHUVRQQHOVDIHW\$/:$<6WXUQRIIDQGXQSOXJ
WKHSULQWHUEHIRUHSHUIRUPLQJWKLVSURFHGXUH
Refer to Figure 28.
To clean adhesive off of the upper and lower cutter blades:
1. Remove the cutter shield by removing the thumbscrew and lock washer.
2. Use a swab moistened with solvent to wipe along the upper cutter blade.
3. To expose the lower cutter blade, turn the cutter motor thumbnut counterclockwise
until you see the “V”-shaped lower cutter blade.
4. Clean the lower blade, following the instructions in step 2.
5. Replace the cutter shield.
6. When you have finished cleaning the cutter module, plug in and turn on the printer.
The lower cutter blade returns to its correct operating position.
NOTE: If the cutter continues to perform unsatisfactorily, contact Brady
Technical Support Service at 1-800-643-8766 or via our web site:
http://www.bradyid.com.
All manuals and user guides at all-guides.com