Braemar BCHV70D1S - Energy Saving and Special Heating

OPERATION cont.
TEMP
Press the TEMP button to toggle
between the following on the indoor
display:-
SET temperature (room target
temperature). SET temperature
is displayed if no icon is shown.
Indoor ambient temperature
Outdoor ambient temperature
(where equipped)
Note:
outdoor temperature display is not
available on some models.
default setting is ‘no display’
Only available on models with a
‘dual 8' display on the indoor unit.
When in COOL, HEAT or DRY modes,
press the SLEEP button to start up the
sleep function.
The icon is displayed on the
remote controller. Default setting is
SLEEP mode ‘OFF’.
In COOL and DRY modes, after
running for one hour, the main unit
SET temperature will increase by 1°C,
then after 2 hours will increase by 2°C,
then will continue to run at this
temperature.
·
·
·
SLEEP
SLEEP cont.
cancel
CHILD LOCK
In HEAT mode, the SET temperature
will decrease by 1°C and then 2°C for
the first 2 hours, and then stay
constant.
Press the I FEEL button to activate this
feature. The remote controller will act
as the temperature thermostat,
sending a temperature reading to the
unit every 10 minutes. By this method,
the unit will react to where the remote
controller is positioned. I FEEL will be
shown on the remote controller
display.
Press the I FEEL button again to
this feature.
The remote controller can be locked
from inadvertent button operation.
I FEEL
FAHRENHEIT / CENTIGRADE
Press both or buttons
simultaneously to lock (or unlock) the
remote controller. The icon will
be displayed, and will blink 3 times
when a button is pressed.
The temperature display can be
toggled between Centigrade and
Fahrenheit scales by pressing the
MODE and buttons simultaneously
while in ‘OFF’ status.
▲ ▼
▼
8
BSHVD1S Series High Wall Inverter Unit
SEELEY INTERNATIONAL – OWNER’S MANUAL
9
OPERATION cont.
LIGHT
8°C HEATING FUNCTION
Press the LIGHT button to toggle
between LIGHT ON and LIGHT OFF
status. Default is LIGHT ‘ON’.
When in COOL mode, press the TEMP
and CLOCK buttons simultaneously to
start Energy Saving function. The
remote controller display will show the
‘SE’ icon. Repeat to cancel.
When in HEAT mode, press the TEMP
and CLOCK buttons simultaneously to
start 8°C Heating function. The
remote display will show and a
selected temperature of ‘8°C’ (46°F).
Repeat to cancel.
ENERGY SAVING