BRAMIDAN X25 - User Manual

Operating
instructions
Bale press
X-series
Manual no. 7995-014
Version 01-05-2012
USA - English edition
(800) 955-0866
info@BATC-compacts.com
www.BATC-Compacts.com

Summary

2 Conditions

Explanation of Symbols

Defines DANGER, WARNING, CAUTION, and HAND symbols for safety communication.

3 Personal Safety

Safety Guidelines and Warnings

Covers operator responsibility, authorized personnel, general safety rules, and specific precautions for safe operation.

4 Use and Function

5 Transport

Lashing and Securing for Transport

Instructions on how to properly lash the baler for secure transport.

Centre of Gravity and Transport Angles

Emphasizes safe transport by limiting leaning angles due to the baler's high center of gravity.

6 Installation

Clearances and Working Area Requirements

Electrical Connection Procedures

Details for connecting single-phase and three-phase motors, including socket requirements and rotation checks.

Three-Phase Connection without Inverter

Guidance for three-phase motors without a phase inverter, including voltage checks.

8 Operating Principles

Power Interruption and Reset Procedure

Emergency Stop and Two-Hand Control

9 The Operating Panel

Control Panel Layout and Description

Button Indicators and Signal Meanings

Explains the meaning of button lights and flashing signals for operational status.

Push Button Operational Functions

Details the functions of compression, binding, premature bale finishing, and platen parking.

11 Filling and Compression

Waste Distribution and Chamber Filling

Compression Cycle Initiation

Steps to start the compression cycle, including door closure.

12 Binding

Binding with Cords or Straps Procedure

Detailed procedure for binding the bale using cords or straps.

Binding with Steel Wire Procedure

Step-by-step guide for binding the bale using steel wire.

Steel Wire Binding Process Steps

13 Ejecting the Bale

Pre-Ejection Checks and Power Safety

Essential checks for the ejection system and power safety before ejecting the bale.

Performing Bale Ejection and Operator Safety

Details on how to perform bale ejection using two-hand control and operator safety.

14 Maintenance

General Maintenance Precautions and Warnings

Safety warnings and requirements for performing maintenance on the baler.

Daily and Weekly Maintenance Checks

Scheduled Maintenance Checks and Care

15 Troubleshooting

Baler Cannot Start Diagnosis

Steps to diagnose and resolve issues when the baler fails to start.

Troubleshooting Start Button Flashing Errors

Troubleshooting Ejection and Leakage Issues

16 Checklist for Safety Check

Safety Checks: Electrical Controls and Switches

Safety Checks: Door and Limit Switches

Additional Safety Switch and Closing System Checks

BRAMIDAN X25 Specifications