Brandt TI2FSOFT - Troubleshooting Common Failures

28
Regarding the air entry and the air vent
After a long time of use, some dust or other dirt may be accumulated at the air entry or air
vent. Use a flexible brush or a detergent to clean it. The body of the appliance can be
cleaned with caution with a dry cloth.
Note: never immerse the induction cooker in the water and do not maintain it with
a steam cleaner.
b) Troubleshooting
Here are the recommended inspections of common failures:
Problems Points to check
After the plug in the socket, the indicator (1) and
the screen do not light up.
- Make sure that the plug is inserted tightly.
- Make sure that the switch, socket, fuse and
power line are in good condition.
The button (1) lights up but heating does not
start.
-
Make sure that the containers are suitable for
induction cooker.
- Sent it to service facility to repair
Heating stops suddenly during operation.
-
Let the appliance cool down
- Let air entry and air vent free
- Set again the timing
- Refer to failure codes
E0
- Inner circuit error
E1
- No pan or the pan is not suitable
E2 - IGBT is overheat
E3 - Input volt is too high
E4 - Input volt is too low
E5 - Heat sensor 1 open or short circuit
E6 - Heat sensor 2 open or short circuit
E1-E3-E4 - Please inspect by self before sending to repair
Failure
codes
E0-E2-E5-E6
- Please contact the customer care service (see your
warranty card for Toll Free number)