What to do if GFI protected outlet trips with Branson 3800 Ultrasonic Jewelry Cleaner?
If your Branson Ultrasonic Jewelry Cleaner unit is plugged into a GFI protected outlet and it trips, connect the unit to an unprotected outlet.
Why my Branson 3800 won't start?
There are several possible causes if your Branson Ultrasonic Jewelry Cleaner won't start: 1. Ensure the unit is plugged into a functioning electrical outlet. 2. If you have an M/MH model, turn the mechanical timer clockwise. 3. For CPX/CPXH models, press the power switch to the ON position. 4. If you have a CPX/CPXH model and the On/Standby key is malfunctioning or the fuse is blown, call the nearest authorized service center.
What to do if Branson 3800 Ultrasonic Jewelry Cleaner does not reach set temperature?
If your Branson Ultrasonic Jewelry Cleaner operates but does not reach the set temperature, it may be due to a malfunctioning heater or sensor components. Call the nearest authorized service center.
Why my Branson 3800 Ultrasonic Jewelry Cleaner operates but does not heat solution?
If your Branson Ultrasonic Jewelry Cleaner operates but does not heat the solution, it could be due to several reasons: * The heater may be malfunctioning, contact an authorized service center. * If you have an MH model, ensure the HEAT is turned ON. * For CPXH models, if the HEAT is not set properly or the membrane is malfunctioning, contact an authorized service center.
General| Brand | Branson |
|---|---|
| Model | 3800 |
| Category | Ultrasonic Jewelry Cleaner |
| Language | English |
Guidelines to prevent injury from electrical hazards.
Guidelines to prevent personal injury and property damage.
Initial setup and preparation steps for the M Series ultrasonic bath.
Details on Timed, Constant, and Auto operating modes for CPXH series.
Steps for performing periodic calibration of CPXH unit temperature measurement.
Instructions for emptying tanks on models without a drain.
Instructions for using the drain valve kit on models with drains.
Common causes and solutions when the unit fails to start.
Diagnosing low ultrasonic activity and potential causes.
Procedure to test ultrasonic cavitation activity using a glass slide.
To Next Page
