8
WARNING: Do not charge fridge / freezer with DC 12V and Solar Panel at the same time!
The fridge could be seriously damaged and pose a potential hazard to you.
NOTE: It is suggested to switch o the refrigerator when charging the battery as the power
supply is designed to mainly power the compressor when the refrigerator is running.
NOTE: When connect to a solar panel, please place the refrigerator in a cool place to dissi-
pate heat. The charging input power should be higher than the working power of the refrig-
erator (about 40-45W), or switch o the refrigerator, otherwise the battery will run out.
NOTE: It is suggested to use 100W optional solar panel. MAX Solar Input Voltage: 50V; MAX
Solar Input Current:10A.
NOTE: When using a solar panel, the battery must be installed as the output of the solar
panel is not suitable to power the refrigerator independently.
NOTE: The factory default is set to Low protection.
Checking Charge Status
When the refrigerator is powered ON and DC / AC power is connected, the battery icon
on display screen will flash to show charging. To charge the fridge / freezer battery
without running the compressor, simply connect the adapters without powering “ON”
the fridge. To view charging status please press and hold button for 3 seconds. The
fridge’s battery status and voltage will be displayed. When the voltage reaches 12.6V
and the battery icon stops flashing, the unit has been fully charged and wiring should
be disconnected to prevent internal component from damage.
AC Charging Management
If the fridge has not been used for a long time, the battery may be discharged, and the
fridge will not power on. Please use the AC adapter to charge the fridge battery and
run the fridge. After the fridge battery has charged up to 30%, you can switch to other
methods for charging.
Car Cigarette Lighter Charging Management
The product has a three-level battery protection function, which not only guarantees the
normal operation of the product, but also protect the battery of the vehicle. When in the
power-on state, long press SET button for 3 seconds and the display screen flashes H,
select low voltage production Low, Medium, and High by clicking button .
To Next Page
Loading...
