9
H should be set when the product is connected to car power, and M or L should be
set when it is connected to a portable battery or other back-up battery. Because of
the dierent output voltages between vehicles, the battery protection level can be set
from H to M or from M to L if there is a voltage protection code F1 shown on the panel.
The battery protection level should be set to H if the product will keep working after
turning o the car engine, or the product may drain the battery.
NOTE: When using the optional battery, the fridge may enter F1 mode. In this case, you
will need to set the protection mode to Low.
Solar Charging Management
To make sure your fridge is being charged by a solar panel, please turn the fridge on
first. The battery icon will flash on the display screen to show the charging status.
The fridge can be turned o while it is being charged. Press and hold button for
over 3 seconds to check the battery status and volatage. An extension cable may be
required to keep the fridge in a cool place (to avoid overheating) while the solar panel
is in the sun. Input power for charging should be higher than the refrigerator power
draw (about 40-45w), otherwise the optional battery will not charge at the same time.
To ensure that solar charging power is higher than refrigerator working power, a 100-
Watt solar panel is advised.
Voltage Reference
To Next Page
Loading...
