Braun 5090cc - Using the Shaver; Manual Cleaning Procedures

27
Using the shaver (see fig. A)
Press the on/off switch (4) to operate
the shaver.
Tips for a perfect dry shave
For best results, Braun recommends
you to follow
3 simple steps:
1. Always shave before
washing your face.
2. At all times, hold the shaver
at the right angle (90°) to
your skin.
3. Stretch your skin and shave
against the direction of your
beard growth.
MultiHeadLock switch (head lock)
To shave hard-to-reach areas (e.g.
under the nose) slide the
MultiHeadLock switch (3) down to
lock the shaver head. The shaver head
can be locked in five positions. To
change position, move the shaver
head with your thumb and forefinger
back or forth. It will automatically click
into the next position.
To set it back into the pivoting
position the MultiHeadLock switch
needs to be slid up again.
Models 5090cc/5070cc/5050cc: For
automatic cleaning in the
Clean&Charge Station the head lock
should be released.
Long hair trimmer
To trim sideburns, moustache or
beard press the release button (8a)
and slide the long hair trimmer (6)
upwards.
Shaving with the cord (models
5090cc/5070cc/5050cc/5030s/
5020s only)
If the shaver has run out of power
(discharged), you may also shave
with the shaver connected to an
electrical outlet via the special cord
set.
Travel lock
• Activation: By pressing the on/off
switch (4) for 3 seconds the shaver
is locked. This is confirmed by a
beep sound and the lock symbol
in the display. Afterwards the
display turns off.
• Deactivation: By pressing the on/
off switch for 3 seconds the shaver
is unlocked again.
Manual cleaning of the
• Switch the shaver on (cordless)
and rinse the shaver head under
hot running water until all
residues have been removed.
You may use liquid soap without
abrasive substances. Rinse off all
foam and let the shaver run for a
few more seconds.
• Next, switch off the shaver, press
the release button (2) to remove the
Foil & Cutter cassette (1) and let it
dry.
• If you regularly clean the shaver
under water, then once a week
apply a drop of light machine oil on
top of the Foil & Cutter cassette.
Alternatively, you may clean the
shaver with a brush:
• Switch off the shaver. Remove the
Foil & Cutter cassette (1) and tap it
91881631_5090cc_Series_5_CN/KR.indd 2791881631_5090cc_Series_5_CN/KR.indd 27 20.07.18 09:3520.07.18 09:35
Business Use - P&G AUTHORIZED POA-00058748 Rev 001 Effective Date 2018-07-26 Printed 2018-10-31 Page 27 of 36