Braun 5090cc - Clean&Charge Station; Charging and Cleaning the Shaver

28
out on a flat surface. Using the
brush, clean the inner area of the
pivoting head. Do not clean the
cassette with the brush as this may
damage it!
Model 5040s only: The shaver
should be cleaned after each foam
usage.
Clean&Charge Station
models
The Clean&Charge Station has been
developed for cleaning, charging,
lubricating, disinfecting and storing
your Braun shaver.
12 Station power socket
13 Lift button for cartridge
exchange
14 Station-to-shaver contacts
15 Clean&Charge Station display
15a Status light
16 Start button
17 Cleaning cartridge
Installing the Clean&Charge
Station (see fig. D)
• Remove the protection foil from the
Clean&Charge Station display.
• Using the special cord set (10),
connect the station power socket
(12) to an electrical outlet.
• Press the lift button (13) at the rear
side of the Clean&Charge Station to
lift up the housing.
• Hold the cleaning cartridge (17)
down on a flat, stable surface (e.g.
table).
• Carefully remove the lid from the
cartridge.
• Slide the cartridge from the rear
side into the base of the station until
it snaps into place.
• Slowly close the housing by pushing
it down until it locks.
Charging the shaver in the
Clean&Charge Station
(see fig. D)
Insert the shaver head down into the
cleaning station.
Important: The shaver needs to be
dry and free from any foam or
soap residue!
The contacts (7) on the back of the
shaver need to align with the contacts
(14) in the station. Push the shaver in
the correct position.
A beep sound confirms that the
shaver sits properly in the station.
Charging will start automatically.
Model 5090cc: The Clean&Charge
Station analyzes the hygiene status.
The status is shown by the cleaning
program indicators
in the
Clean&Charge Station display (15)
more details see chapter «Cleaning
programs» below.
Cleaning the shaver
(see fig. D)
When the cleaning indicator
lights
up in the shaver display, insert the
shaver into the Clean&Charge
Station, upside down and with the
front showing (with released head
lock/contact alignment/beep sound).
Cleaning programs
5090cc: The hygiene status will be
analyzed and one of the following
program indicators will light up.
91881631_5090cc_Series_5_CN/KR.indd 2891881631_5090cc_Series_5_CN/KR.indd 28 20.07.18 09:3520.07.18 09:35
Business Use - P&G AUTHORIZED POA-00058748 Rev 001 Effective Date 2018-07-26 Printed 2018-10-31 Page 28 of 36