29
short economical cleaning
normal level of cleaning
high intensive cleaning
5070cc/5050cc: One standard
cleaning program included.
Start automatic cleaning
Start the cleaning process by
pressing the start button (16). If
status light (15a) does not shine
(Clean&Charge Station switches to
stand-by after ca. 10 minutes), press
start button twice. Otherwise cleaning
will not start. For best shaving
results, we recommend cleaning
after each shave.
Each cleaning program consists of
several cycles, where cleaning fluid is
flushed through the shaver head.
Depending on your Clean&Charge
Station model and/or program
selected, the cleaning time takes up
to 3 minutes. During this time the
status light blinks. Leave the shaver in
the station for drying.
It takes several hours until remaining
moisture evaporates depending on
the climatic conditions. Afterwards
the shaver is ready for use.
After completing the cleaning and
charging procedure, all indicators
turn off.
Removing the shaver from the
Clean&Charge Station (see fig. E)
Hold the Clean&Charge Station with
one hand and tilt the shaver slightly to
the front to release it.
Cleaning Cartridge / Replacement
(see fig. F)
When the level indicator
lights up
permanently red, the remaining fluid
in the cartridge is sufficient for about
3 more cycles. When the level
indicator blinks red, the cartridge
needs to be replaced - (about every
4 weeks when used daily.)
After having pressed the lift button
(13) to open the housing, wait for a
few seconds before removing the
used cartridge to avoid any dripping.
Before discarding the used cartridge,
make sure to close the openings
using the lid of the new cartridge,
since the used cartridge will contain
contaminated cleaning solution.
The hygienic cleaning cartridge
contains ethanol or isopropanol
(specification see cartridge), which
once opened will naturally evaporate
slowly into the surrounding air. Each
cartridge, if not used daily, should be
replaced after approximately
8 weeks to ensure optimal
disinfection.
The cleaning cartridge also contains
lubricants for the shaving system,
which may leave residual marks on
the outer foil frame and the cleaning
chamber of the Clean&Charge
Station. These marks can be removed
easily by wiping gently with a damp
cloth.
Accessories
Braun recommends changing your
shaver’s Foil & Cutter cassette every
91881631_5090cc_Series_5_CN/KR.indd 2991881631_5090cc_Series_5_CN/KR.indd 29 20.07.18 09:3520.07.18 09:35
Business Use - P&G AUTHORIZED POA-00058748 Rev 001 Effective Date 2018-07-26 Printed 2018-10-31 Page 29 of 36
To Next Page
Loading...
